The maintenance of air compressors is very important to the operation and service life of the equipment。However, many users do not properly set the maintenance time in actual operations, resulting in device performance degradation or even faults。This article will give you more detailsPneumatic screw air compressorThe maintenance time setting method helps you better protect your equipment。

Pneumatic screw air compressor maintenance time setting principle

1, according to the use of equipment to develop maintenance plans: air compressor in different industries, different working conditions of the use of time and load is different, therefore, maintenance time should be set according to the actual situation of the equipment。In general, it is recommended to perform maintenance every 4-6 months。

2, refer to the maintenance manual provided by the manufacturer: the major brands of air compressor have a certain maintenance cycle and requirements, users can refer to the recommended maintenance time and methods in the equipment manual to set。

3、 Adjust according to the operating status of the equipment: In the actual use process, pay close attention to the operating status of the equipment, such as noise, vibration, exhaust temperature, etc。If abnormal conditions are found, maintenance should be carried out in time to avoid equipment failure。

Pneumatic screw air compressor maintenance of the specific steps

1、 Regular replacement of lubricating oil: lubricating oil is an important lubricant for air compressors, long-term use will form sludge and carbon deposits, affecting equipment performance。It is recommended to replace the lubricating oil every 2000-4000 hours to ensure the normal operation of the equipment。

2, clean filter: filter is an important barrier to prevent dust and impurities into the air compressor。After long-term use, the filter will accumulate a lot of dirt, affecting the ventilation effect。It is recommended to clean the filter every 6-12 months to ensure air quality。

3, check the belt: the belt is a key part of the drive air compressor, long-term use will lead to wear, loosening and other problems。It is recommended to check the tension and wear of the belt every 6 months and replace it if necessary。

4、 Check seals: O-rings, leather rings and other seals are key components to prevent gas leakage。After a long time of use, seals will age and wear, affecting the performance of the equipment。It is recommended to check the use of seals every 4-6 months and replace them if necessary。

The maintenance time setting of the air compressor should follow the above principles and be adjusted according to the actual situation of the equipment。Only by doing a good job of maintenance can we ensure the normal operation and service life of the equipment。At the same time, regular consultation and advice to professional maintenance personnel is also a key way to improve the level of equipment use。I hope this article can help your pneumatic screw air compressor to maintain good working condition。